Surfaces of old doors are no longer accurate. Layers of paint are applied several times were cracked and broken. Here only helps one thing: we must remove the old varnish and re-paint the basic gates. Here are some tips.

REMOVING OLD PAINT LAYERS

Two were able to remove old layers of paint: to burn or melt. When the boiler heater, because it heats up and easy to remove with a spatula. To download the recommended means of odlmekivanje (liquids that are applied with a brush. Ensure instructions for use. According to the thickness of lacquer coating layer dissolves after one minute, or until after five minutes).

REPAIR DAMAGED SITE OF

After removing the color plate grinds coarse sandpaper or a vibrating sander in the direction of wood fibers. Then to rebuild or repair the damaged areas in wood. Deep cracks meet or wooden wedge Gita. Thus the previously discussed here a few times will smooth spatula.

GRINDING AND FUNDAMENTAL DYEING

After a rough preliminary work we have carefully sanded panels, first coarse and then fine sandpaper, but only in the direction of wood fibers. It would be good to take off the door and laid horizontally. Dye should always start from the thin coating and then the thick: base coat is thin, a little more dense coating paint and at the end of a thick layer of icing color.

SURFACE TREATMENT IS IMPORTANT

Panels will buff multiple thin coating of artificial resins Gita. It is parallel to the texture of wood, and serve as a tool blades of different widths. Grinding can be dry or wet. Wet grinding has the advantage that when the work is free of dust, and only the finer grinding. For this there are special sandpaper.

MEĐUBOJENJE and final painting

Machined plates of both intermediate coatings (fillers). For better coverage of a sealer is easy, but nuanced in tone paint finish. Here we can use colors for shading.